2013-09-19
New functions for field information, 3D handling and mapping in the new version of Topocad – Topocad 14.4
Topocad version 14.4 is now released
by the company Adtollo. It is estimated to be the last 14.x version of
Topocad. In 14.4 Adtollo introduces new functions for field information and 3D handling.
The
big news in Topoad 14.4 when it comes to field information is a command that
shows deviations from terrain models and the input from the Topocad Field
module. They are shown through green and red arrows in the drawing together
with numbers that indicate the deviation from the position on the field in
comparison to for example a terrain model.
Another
new function enables viewing the map in three dimensions (both in cross section,
plane, side and other selectable view) while being positioned on one section.
”We’ve
built in several functions for handling data and views from machine guidance
and field data direct in the drawing. Thanks to modern handheld units it is now
fully functional bringing the drawing in total out on the field and getting
immediate control of your field data in the computer”, says Tomas Sandström director of Surveying & Mapping department at
Adtollo.
”The
new section view is amazing and you can open up 1, 2, 3 or 4 views at the same
time, viewing your position interactively from different directions. Now that
we’ve started getting data in 3D it is exciting sweeping through the
environment from different angles and at the same time being in full control”, Tomas
Sandström adds.
Constructing
a map in 3D
”It is a current phenomenon for many to construct
their maps in three dimensions. With Topocad 14.4 we’re coming up with a new
command that automatically creates areas on vertical objects in relation to
terrain models or point clouds. Those who i.e. have a digitized ridge can use
the tool to create the facade surfaces in 3D – directly in the drawing. The
command is quick and effective and will create manageable surfaces from terrain
models”, states Tomas Sandström.
New
functions for mapping and topology verification are also introduced in Topocad
14.4. You can now edit and save geo referenced images and the topology
verification now handles closed polylines in two different manners.
”The
new topology verification is semi-automatic. It verifies lines that are almost
closed by comparing them to one or more external points. It also commits a
self-check where the automatic connection function is used”, says Tomas
Sandström.
The
verification can be semi-automatic or completely automatic and results in areas
without gaps. It is a rapid function that is easily overlooked.
“It
gives mappers a tool that solves the problems with gaps in areas”, Tomas
Sandström concludes.
Information about the company: Adtollo AB
The news is presented in cooperation with MyNewsdesk